|
|
 |
Solar
Motion Light |
At dusk, the built-in photocell switches on
the super bright LED to illuminate your pathway. The soft
grow ensues safety and creates a warm garden atmosphere. The
motion sensor turns the unit to full brightness automatically
after sensing moving heat sources (such as a walking person
or large animal) in its coverage area. When motion stops,
light will remain on for another 15 seconds, then return to
the LED illumination.
|
| |
|
|
|
| |
|
| |
|
|
| |
| Features: |
| 1. |
LED on at dusk |
| 2. |
Low voltage bulb on with motion at dusk |
| 3. |
No wiring required |
| 4. |
Environmental friendly |
|
| |
Specifications:
|
| 1. |
Detection angle: 110 |
| 2. |
Operating distance: up to 25 feet |
| 3. |
Delay on-time: 15 seconds |
| 4. |
Rated current for LED: 15-25mA |
| 5. |
Bulb: 4.8V/0.5A |
|
| |
| Operation: |
| 1. |
Remove the top cover from the lampshade by twisting
the top cover. Slide the switch to "ON" position
and place the top cover back into position. The unit is
now ready to function. NOTE: When initially turned on.
The unit has a warm-up period for about 40 seconds. During
this period, it does not respond to motion. |
| 2. |
During sunny daylight hours, solar panel charges the
built-in rechargeable batteries (4 AA Ni-CD) for nighttime
use. NOTE: The rechargeable batteries were fully charged
at the factory. However, the batteries might have been
partially discharged during transportation. It is recommended
that you place the unit under the sun for 2 days to recharges
the batteries before use. |
| 3. |
Marker Mode: At dusk, the built-in photocell switches
on the super bright LED to illuminate your pathway. |
| 4. |
Motion mode: At dusk, motion detector turns the low
voltage bulb on when motion is detected. When motion stops,
light remains on for anther 15 seconds, then returns to
Marker Mode. NOTE: The unit will only respond to motion
again 10 seconds after the low voltage bulb was turned
off. |
|
| |
| Installation: |
| 1. |
Choose a location where it has the maximum exposure
to sunlight during daylight hours. Avoid putting the unit
in the shadow of trees or under eaves. |
| 2. |
Whenever possible, locate the unit so that motion moves
across the coverage area, not directly towards or away
from the motion sensor. It is because the motion sensor
is more sensitive to motion across it, not towards or
away from it. |
| 3. |
To the Ground: Vertically insert the stake into the
ground. Connect one of pole sections to the stake. If
you need extra length, connect the second pole section
to the first one. Place the unit onto the other end of
the pole section. |
| 4. |
To the Wall: Secure the wall mounting plate onto the
wall by using mounting screws. Connect one of pole sections
to the wall mounting plate. If you need extra length,
connect the second pole section to the first one. Place
the unit onto the other end of the pole section. |
|
| |
| Sizes and weight list |
| box size(cm) |
carton size(cm) |
GW |
pcs /ctn |
| 19*19*20 |
76*40*34 |
14.9 |
16 |
|
|
| |
|
